PRODUCTS: ROOF SYSTEMS

Inland Buildings manufacturers two types of roof systems.

Dyna Rib (DR)
IN-LOC™ Standing Seam Roof System

The Dyna Rib (DR) roof panel is a traditional through fastened (screw down) panel that provides efficiency and economy in metal roofing. It has a neat, clean sidelap with a siphon groove and a full-return purlin bearing leg. The panel provides full 36" coverage, comes with rubber eave closures and has available a UL90 wind uplift rating. DR is available in painted or Galvalume® finishes and in 24 and 26 gauge materials.

The IN-LOC™ Standing Seam Roof System provides the maximum in performance, reliability and cost efficiency. IN-LOC™ utilizes a proven, patented seam that provides superior wind and weather protection under all roof loading conditions.

Standard industry tests on various roof configurations have shown that the wind loading on a roof fall into three zones. These range from the lowest load (approximately 80% of the roof surface) to a higher loading around the perimeter of the roof, and finally, to the highest load on the roof which is at the corners.

IN-LOC™ accommodates all three roof zones by the simple and efficient execution of one of three seaming shapes. Each seam shape is formed in the field after the roofing panels have been installed. Precise roof wind loading requirements are met with IN-LOC™, without added roofing materials or altering panel/purlin placements, by simply selecting the appropriate seaming method to meet the uplift load for the zone. There is no need to change purlin spacing and no need for external clips over the seam. In fact, most projects can be completed with a consistent purlin spacing, one size panel and one type of clip throughout - resulting in faster erection and lower overall cost for materials and installation.

There are three seaming versions of IN-LOC™ available.

	The Roll-and-Lock seam is accomplished by hand seaming the seam at each clip. This seam provides superior water resistance by isolating the sealant from dislodging or separation during severe wind. The seaming step is simple as all that is required is one rotation of the hand seamer at each clip, locking the panel to the roof structure.
	The Triple-Lock seam is accomplished by seaming the entire seam with an electric seamer. Triple-Lock uses a 360° plus 90° seam that structurally isolates the seam from severe wind loading by a combination of design factors.
	The Quadri-Lock seam can be used in extremely high wind areas to provide allowable uplift loads of 64 PSF to 120 PSF. The additional strength is produced by the use of a specialized electric seamer.

Specifications
IN-LOC™ panels are standard 24 gauge material and available in Galvalume® , Ceram-A-Star® 950 or Fluropon® 70% Kynar finishes.

IN-LOC™ Certifications
Underwriters Laboratories UL-90 Classification Construction No. 562
Corps of Engineers CEGS 07416 Uplift Test
ASTM E 1592 Uplift Test (three tests each span each gauge)
ASTM E 1680 Air Infiltration
ASTM E 1646 Water Leakage

Inland Buildings is a wholly owned subsidiary of Behlen Mfg. Co.
©2005 Inland Buildings All Rights Reserved
Inland Buildings
2141 Second Avenue, SW
Cullman, Alabama 35055
Phone: (800) 438-1606 Fax: (800) 438-1626

Home    News    Quote Request    Contact Us    Site Map